Pillbox Antenna Design and Simulation

A pillbox antenna is a linearly polarized cylindrical reflector embedded between two Parallel plates. It is usually fed by a waveguide. The pillbox is part of a family of antennas called fan beam antennas which produce a wide beam in one plane and a narrow beam in the other. The pillbox antenna can be dual polarized and is also a relatively wide bandwidth antenna.

pil1.jpgThe advantages of using a pillbox antenna for radar applications are

  • It is easy to design and the cost of production is low.
  • It is dually-polarized and it is also a wide band antenna.
  • It has a high power handling capability

The pillbox feed is traditionally located at the focal point of the reflector. For symmetrical antennas this is located in the middle of the aperture. Either a pin or waveguide feed can be used, depending on the system requirements. Further variations of these feeds can be found through the use of stubs which are used to obtain better impedance matching and reflector illumination, not discussed in this dissertation.

Pillbox Antenna with Waveguide Feed

Below is Pillbox antenna designed at 39 GHz. The feed is a waveguide feed. The pil2.jpgwaveguide feed is first designed separately from the system. Flares are attached to the sides and optimized for the best reflection coefficient. Once the optimal configuration is obtained, the waveguide is used as a feed in the pillbox structure. Larger flares generally give a better reflection coefficient, but effectively increase the aperture of the waveguide, lowering the beam-width. The maximum gain of antenna is 25.6 dBi. Antenna polar plot (phi=90 degree) and E-field plot is shown below in figure.


The parabolic reflector reflects rays incident on its center directly back to the feed, this together with the narrow beam-width of the waveguide causes the majority of the energy to be reflected back into the waveguide, resulting in the impedance mismatch. One solution to this problem is to design the waveguide to have a wider beam-width and to radiate less energy in the centre through the use of stubs. Enlarging the pillbox width should also decrease the amount of energy reflected back into the feed.


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s